Proxim ORiNOCO AP-800 Installation And Management Manual page 210

8.8.5.2 Attaching the Serial Port Cable
1. Connect one end of the serial cable to the device and the other end to a serial port on your computer.
2. Power on the computer and the device.
8.8.5.3 Initializing the IP Address using CLI
After connecting the cable to the serial port, you can use the CLI to communicate with the device. CLI supports the
most-generic terminal emulation programs. In addition, many web sites offer shareware or commercial terminal programs
that you can download. Once the IP address has been assigned, you can use the HTTP interface or the Telnet to complete the
configuration.
Follow these steps to assign an IP address to the device:
1. Open your terminal emulation program and set the following connection properties:
•
Com Port: COM1, COM2 and so on depending on your computer
•
Baud Rate: 115200
•
Data Bits: 8
•
Stop Bits: 1
•
Flow Control: None
•
Parity: None
The terminal display shows Power On Self Tests (POST) activity, and then displays the software version. It prompts you
to enter the CLI username and password. The commands to enter the username and password are as follows.
Username: admin
Password:
This process may take up to 90 seconds.
2. Enter the CLI Username and password (By default username is admin and password is public). The terminal displays a
welcome message and then the CLI Prompt:
System Name>
3. Change the IP address and other network values by using the following CLI commands (use your own IP Address and
Subnet Mask).
T8000-00:00:00>enable
T8000-00:00:00#configure
T8000-00:00:00(config)# network
T8000-00:00:00(config-net)# ip
T8000-00:00:00(config-net-ip)# ethernet-ip-table rowedit 1
Possible completions:
<[Enter]>
address-type
ipaddress
mask
T8000-00:00:00(config-net-ip-etherip)# rowedit 1 ipaddress <IP Address>
Changes in Ethernet IP Address requires reboot.
T8000-00:00:00(config-net-ip-etherip)# rowedit 1 mask <Subnet Mask>
Changes in Ethernet Subnet mask requires reboot.
T8000-00:00:00(config-net-ip-etherip)# rowedit 1 address-type <static/dynamic>
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Enter show ip to find the current IP address of the device.
Execute this command
Configure the Address type
IP Address of the network interface
subnet mask of the network interface
Troubleshooting
210