Proxim ORiNOCO AP-800 Installation And Management Manual page 50

2. Configure the following parameters:
•
11n AMPDU (Aggregated MAC Protocol Data Unit) Status: This parameter enables the user to aggregate
several MAC frames into a single large frame to achieve high throughput. By default, AMPDU status is enabled. To
disable, click Disable from the drop down menu.
•
AMPDU Max Num Frames: Specifies the maximum number of frames that are aggregated and transmitted as a
single Protocol Service Data Unit (PSDU) by the Physical Layer. By default, the AMPDU Max Num Frames taken is
64. To configure, enter a value ranging from 2 to 64 frames.
•
AMPDU Max FrameSize: Specifies the maximum AMPDU frame size (in bytes) that can be transmitted. By
default, the AMPDU Max FrameSize taken is 65535 bytes. To configure, enter the frame size ranging from 1k to
64k bytes.
•
Frequency Extension: Specifies the frequency extension for the wireless interface. By default, Upper Extension
Channel is taken. To configure, select a frequency extension between Lower Extension Channel or Upper
Extension Channel, from the drop down menu.
: Applicable only for 40 MHz bandwidth.
3. Click OK, to save the configured parameters.
: If you have changed any of the Wireless 11n Properties with an asterisk symbol marked against it, then reboot the
device.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-10 Wireless Interface-1 11n Properties
Device Configuration Using Web Interface
50