User Mode; Privileged Mode - Proxim ORiNOCO AP-800 Installation And Management Manual

6.4.1 User Mode

The moment you logon to the device, with Username and Password, you enter the User mode. In this mode, you can view the
configuration of few parameters only. For configuring the device, you must be in the privileged mode which can be entered
by executing the "enable" command from the User Mode.
Example:
AP-00:7D:09>
To view the commands in user mode, type Question Mark(?).
AP-00:7D:09>?
To use the privileged mode, you need to type enable command from User mode.

6.4.2 Privileged Mode

Use the following command to access the privileged mode:
AP-00:7D:09>enable (this command enables the privileged mode).
In this mode, you can view all the configured parameters of the device by using show ?. This mode is identified by a pound
sign (#) at the command prompt.
AP-00:7D:09#
To list the commands in the Privileged mode, enter ?. This lists the following:
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09 > ?
Possible completions:
clear Clear Log Messages
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from EXEC
ping Send Echo Messages
show Show Running System Information
traceroute Trace Route to Destination
AP-00:7D:09 # ?
Possible completions:
clear Clear Log Messages
configure Enter Global Configuration Mode
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from EXEC
generate Generate config file
load Load configuration
ping Send Echo Messages
show Show Running System Information
traceroute Trace Route to Destination
Device Configuration, Management and Monitoring using CLI
134