Proxim ORiNOCO AP-800 Installation And Management Manual page 63

To configure the RADIUS Server Profile, do the following:
1. Navigate to CONFIGURATION > Security > RADIUS. The RADIUS Server Profile screen appears:
2. Configure the following parameters:
•
Profile Name: Specifies the RADIUS profile name which is used to identify a set of four RADIUS servers configured
one per Accounting, Authentication, Secondary Accounting and Secondary Authentication.
•
Max ReTransmissions: Specifies the maximum number of times an authentication request may be retransmitted.
By default, it is set to 3. To configure, enter the Max ReTransmissions in the range of 0 to 3.
•
Message Response Time: Specifies the response time in seconds that the device should wait for the RADIUS
server to respond to a request. By default, it is set to 3. To configure, enter the Message Response Time
between the range 3 to 12 seconds.
•
Re Authentication Period: Specifies the time period after which the device must re-authenticate the client with
the RADIUS server. By default, the Re-authentication Period is set to 0. To configure, enter the value between
the range 900 to 65535 seconds.
: If the value is set to "0", then the re-authentication is disabled. This parameter does not apply for clients
using RADIUS MAC Authentication.
3. Configuration of the four RADIUS Server parameters in the RADIUS Server Profile Table, is also recommended.
a. Primary Authentication Server
b. Secondary Authentication Server
c. Primary Accounting Server
d. Secondary Accounting Server
Each of the above RADIUS Servers should be configured with the following parameters:
•
Server Type: Specifies a read-only parameter which indicates the type of RADIUS Server. Server Type may vary
between Primary Accounting Server, Secondary Accounting Server, Primary Authentication Server and
Secondary Authentication Server.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-21 RADIUS Server Profile
Device Configuration Using Web Interface
63