Error Messages; Help Message - Proxim ORiNOCO AP-800 Installation And Management Manual

6.2.2.1 Key Combination Operation
DEL, Backspace (BS)
Ctrl-B
Ctrl-F
Ctrl-A
Ctrl-E
Ctrl-C
TAB
?

6.2.3 Error Messages

The following table describes the error messages associated with improper inputs.
%Unknown command
%Invalid Input value detected
Error in configuration parameters,
Please Verify your Configuration
%Incomplete command

6.2.4 Help Message

When you type any command at the CLI and then press Enter, it displays the help on the inputs that can be used with the
command.
Here, vlan-status is the CLI command and input ranges that can be used within the command are enable and disable. You
can give 1 to enable or 2 disable.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Key
Error Message
AP-00:7D:09 (config-vlan)# vlan-status
% Input Range <enable(1)/disable(2)> required
AP-00:7D:09 (config-vlan)# vlan-status enable
Or
AP-00:7D:09 (config-vlan)# vlan-status 1
Device Configuration, Management and Monitoring using CLI
Description
Deletes previous character
Moves back along the command line
Moves forward along the command line
Moves to the beginning of the command line
Moves to the end of the command line
Exits from one level
Attempts command completion
Provides command listing
An unknown command has been entered at
the command prompt.
An invalid value has been entered at the
command prompt.
An Invalid configuration entered at the
command prompt.
An incomplete command has been entered.
Description
130