Proxim ORiNOCO AP-800 Installation And Management Manual page 108

4.3.3.1 SNMP Trap Host Table
The SNMP Trap Host Table contains the following information:
•
IP Address: Specifies the IP address to which SNMP traps will be delivered.
•
Password: Specifies the password set to access the SNMP Trap Host Table entry.
: Applicable only to SNMP v1-v2c.
•
Comment: Specifies any comment on the SNMP Trap Host Table entry.
•
Entry Status: Specifies the entry status set for each table entry. To configure, select either Enable, Disable or
Delete. If Enabled, it allows the device to send SNMP traps to the specified IP address. If you want to delete any table
entry from the SNMP Trap Host Table, select Delete.
Click OK and reboot the device, if you have changed the values in the SNMP Trap Host Table.
4.3.3.2 Add a new Entry to the SNMP Trap Host Table
To add new entries in the SNMP Trap Host Table, click Add. The SNMP Trap Host Table Add Row screen appears.
1. Configure the following parameters:
•
IP Address: Enter the IP address to which SNMP traps will be delivered, in the IP Address box.
•
Password: To access SNMP traps, enter password in the Password box.
: Applicable only to SNMP v1-v2c.
•
Comment: Enter any comments in the Comment box.
•
Entry Status: Select the Entry Status as either Enable or Disable from the drop down menu.
2. Click Add.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-17 SNMP Trap Host Table Add Row
Device Management Using Web Interface
108