Commissioning; Setting An Ip Address - WAGO 765-4102/0100-0000 User Manual

765-4102/0100-0000

Commissioning

10

10.1 Setting an IP Address

The module requires an IP address so it can be addressed via the ETHERNET network.
The module has no IP address when delivered. The module can get the IP address in
various ways.
• The PROFINET IO-Controller sets the IP address when PROFINET starts up.
• You can set the IP address permanently or temporarily with the PROFINET engineer-
ing tool of the IO controller. Read the documentation of the PROFINET engineering
tool.
• You can set the IP address with the "ETHERNET Device Configuration" software as
described below. The software is available for download from
kb.hilscher.com/display/ETHDEVCFG.
Setting the IP Address with the "ETHERNET Device Configuration" Software
• Launch the "ETHERNET Device Configuration" software.
• In the menu under Options > Protocols, verify that the DCP option is checked. If the
DCP option is not checked, check it.
The software lists all the devices found on the local network. Under IP Address, ei-
ther 0.0.0.0 (i.e., no IP address set) or the IP address set in the product appears.
• Click Search Devices.
• Identify the device, e.g., on the basis of the MAC address or the product type IO
System Field-765-xxxx.
• Use the mouse cursor to select the corresponding device from the list of devices
found.
• Click Configure > Set IP Address.
The dialog for setting the IP address appears:
Product manual | Version: 2.1.0
8PORT IOL-B FLD PN DC 24V 2.0A
ü https://
Figure 11: List of the Products Found on the Local Network
Commissioning
65