WAGO I/O System 750
750-1505 16DO 24VDC 0.5 A, low-side switching
Pos : 71 /All e Seri en (Allgemei ne Module)/Ü berschriften/Ebene 1/Geräte ansc hließ en - Übersc hrift 1 @ 3\mod_1234172889468_21.doc x @ 27460 @ 1 @ 1
6
Connect Devices
Pos : 72 /Serie 750 ( WAGO I/O SYSTEM)/Anschli eßen/Leiter an Pus h-in CAGE CLAMP® ansc hließ en - Ü bersc hrift 2 und T ext @ 6\mod_1258964749000_21.doc x @ 44640 @ 2 @ 1
6.1
Connecting a Conductor to the Push-in CAGE
CLAMP
The Push-in CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each Push-in CAGE CLAMP
Only one conductor may be connected to each Push-in CAGE CLAMP
connection.
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Terminate both solid and stranded or ferruled conductors by simply pushing them
in - no tool required. For all other types of conductors, Push-in CAGE CLAMP
must be opened for connection with an operating tool with a 2.5 mm blade (order
no. 210-719).
1.
To open the Push-in CAGE CLAMP
opening above the connection.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the Push-in CAGE CLAMP
conductor is then clamped firmly in place.
Figure 10: Connecting a Conductor to a Push-in CAGE CLAMP
Pos : 73 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
®
®
connection is appropriate for solid, stranded and
Public
Connect Devices
insert the actuating tool into the
®
®
simply remove the tool - the
®
33
connection!
®
®
®
Manual
Version 1.1.0