Connect Devices; Connecting A Conductor To The Cage Clamp; Figure 10: Connecting A Conductor To A Cage Clamp - WAGO -I/O-SYSTEM 750 Manual

30

Connect Devices

Pos : 72 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Ansc hließ en/Ger äte ansc hließen - Ü bers chrift 1 @ 3\mod_1234172889468_21.doc x @ 27460 @ 1 @ 1
5 Connect Devices
Pos : 73 /Serie 750 ( WAGO-I/O-SYST EM)/Ans chli eßen/Leiter an C AGE C LAM P ans chli eßen ( allgemei n) - Übersc hrift 2 und Text @ 3\mod_1225448660171_21.doc x @ 24928 @ 2 @ 1
5.1

Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length:
Nominal cross section
WAGO product:
1. For opening the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. For closing the CAGE CLAMP
now clamped firmly in place.

Figure 10: Connecting a Conductor to a CAGE CLAMP

Pos : 74 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
®
connection is appropriate for solid, stranded and
8 mm
2
: 1 mm for 2 conductors with 0.5 mm
max.
216-103 or products with comparable properties
®
insert the actuating tool into the opening
®
simply remove the tool. The conductor is
WAGO-I/O-SYSTEM 750
750-531 4DO 24V DC 0.5A/ 2-conductor
®
!
®
.
®
®
2
each
Manual
Version 1.3.0