Connect Devices; Connecting A Conductor To The Cage Clamp; Figure 14: Connecting A Conductor To A Cage Clamp - WAGO 8FDI 24V PROFIsafe 750-662/000-004 Manual

Table of Contents

Connect Devices

6.1

The WAGO CAGE CLAMP

finely stranded conductors.

Only connect one conductor to each CAGE CLAMP

Only one conductor may be connected to each CAGE CLAMP

Do not connect more than one conductor at one single connection!

If more than one conductor must be routed to one connection, these must be

connected in an up-circuit wiring assembly, for example using WAGO feed-

through terminals.

For opening the CAGE CLAMP

above the connection.

Insert the conductor into the corresponding connection opening.

For closing the CAGE CLAMP

now clamped firmly in place.

Manual

Version 1.0.0, valid from HW/SW Version 01/01

750-662/000-004 8FDI 24V PROFIsafe

connection is appropriate for solid, stranded and

insert the actuating tool into the opening

simply remove the tool. The conductor is

WAGO I/O System

Table of Contents

Table of Contents