Connect Devices; Connecting A Conductor To The Cage Clamp; Figure 10: Connecting A Conductor To A Cage Clamp - WAGO 750-484 Manual

2 ai 4-20 ma hart ex i 2-channel-analog input module 4-20 ma hart, ex i

Hide thumbs Also See for 750-484:

Table of Contents

Connect Devices

7.1

The WAGO CAGE CLAMP

finely stranded conductors.

Only connect one conductor to each CAGE CLAMP

Only one conductor may be connected to each CAGE CLAMP

Do not connect more than one conductor at one single connection!

If more than one conductor must be routed to one connection, these must be

connected in an up-circuit wiring assembly, for example using WAGO feed-

through terminals.

For opening the CAGE CLAMP

above the connection.

Insert the conductor into the corresponding connection opening.

For closing the CAGE CLAMP

now clamped firmly in place.

connection is appropriate for solid, stranded and

insert the actuating tool into the opening

simply remove the tool. The conductor is

V 1.2.0 HW-Version 04, SW-Version 03

WAGO-I/O-SYSTEM 750

750-484 2 AI 4-20 mA HART Ex i

Manual

Table of Contents

Table of Contents