Inserting A Memory Card During Operation; Removing The Memory Card During Operation - WAGO I/O System 750 Manual

78 Functions
5.2.3

Inserting a Memory Card during Operation

The fieldbus nodes and the PLC program are running.
Insert a memory card during ongoing operation.
During normal operation, the memory card is incorporated into the file system of
the controller as a drive.
No automatic copy procedures are triggered.
The LED above the memory card flashes yellow during the access.
The memory card is then ready for operation and available under /media/sd.
5.2.4

Removing the Memory Card during Operation

The fieldbus node and the PLC program are in operation and the memory card is
plugged in.
Remove the memory card during ongoing operation.
Data can be lost during writing!
Note that if you pull the memory card out during a write procedure, data will be
lost.
The LED above the memory card flashes yellow during the attempted access.
The controller then works without a memory card.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR