Table of Contents
Advertisement
66
Quickstart Description
3.4.1.1
Inserting a Memory Card
1.
Use an activation tool or a screwdriver to open the transparent cover flap by
folding it upwards.
2.
Hold the memory card so that the contacts are visible on the left side and the
sloping edge is towards the bottom, as depicted in the figure above.
3.
Insert the memory card into the slot of the fieldbus controller.
4.
Push the memory card all the way in. When you let go, the memory card
will move back a little and then snap in.
5.
Push the cover flap back in by folding it downwards until it snaps in.
3.4.1.2
Removing the Memory Card
1.
Use an activation tool or a screwdriver to open the transparent cover flap by
folding it upwards.
2.
To remove the memory card, first press it into the slot.
This loosens the mechanical locking
3.
As soon as you let go of the memory card, the memory card is pushed out a
bit and you can remove it.
4.
Push the cover flap back in by folding it downwards until it snaps in.
Pos : 52 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
750-880, -881, -882 ETHERNET Programmable Fieldbus
WAGO-I/O-SYSTEM 750
Quickstart Reference
Version 1.0.0
Hide quick links:
Advertisement
Chapters
Table of Contents
