Table of Contents
Advertisement
56 •
Programmable Field Bus Controller 750-833
Hardware
3.2.6 Configuration and Programming Interface
The configuration and programming interface is located behind the cover flap.
This is used to communicate with WAGO-I/O-CHECK and WAGO-I/O-PRO
as well as for firmware transmitting.
Fig. 3.2.6-6: Configuration interface
The communication cable (750-920) is connected to the 4 pole male header.
Warning
The communication cable 750-920 must not be connected or disconnected
while the coupler/controller is powered on!
g01xx07e
WAGO-I/O-SYSTEM 750
Bus System
Advertisement
Table of Contents
