Example usage:
To view the current SNMP trap support:
DGS-1210-28MP/ME:5# show snmp traps
Command: show snmp traps
SNMP Traps
SNMP Authentication Traps
Coldstart Traps
Warmstart Traps
Linkchange Traps
RSTP Port State Change
Firmware Upgrade State
Port Security violation State
IMPB violation State
Loopback detection State
DHCP server screening State
Duplicate IP Detected State
DGS-1210-28MP/ME:5#
enable snmp linkchange_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the SNMP link change trap function:
DGS-1210-28MP/ME:5# enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
DGS-1210-28MP/ME:5#
disable snmp linkchange_traps
Purpose
Syntax
Description
Parameters
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To enable SNMP link change traps support on the Switch.
enable snmp linkchange_traps
The enable snmp linkchange_traps command is used to enable
SNMP link change traps support on the Switch.
None.
Only Administrator or operator-level users can issue this command.
To disable SNMP link change traps support on the Switch.
disable snmp linkchange_traps
The disable snmp linkchange_traps command is used to disable
SNMP link change traps support on the Switch.
None.
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
: Enable
108