Banner Commands; Config Log_Save_Timing - D-Link DGS-1210/ME Series Reference Manual

The Banner commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command

config log_save_timing

show log_save_timing
show log
Each command is listed in detail, as follows:
config log_save_timing
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the time interval as every 30 minutes for saving logs:
DGS-1210-28MP/ME:5# config log_save_timing time_interval 30
Command: config log_save_timing time_interval 30
Success.
DGS-1210-28MP/ME:5#
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
[log_trigger | on_demand | time_interval <minutes 1-65535>]
{index <indexlist> | module <string 32> | severity [warning | all | informational]}
Used to configure the method of saving logs to the Switch's Flash
memory.
config log_save_timing [log_trigger | on_demand | time_interval
<minutes 1-65535>]
This config log_save_timing command is used to configure the
method used in saving logs to the Switch's Flash memory.
log_trigger – Users who choose this method will have logs saved to
the Switch every time a log event occurs on the Switch.
on_demand – Users who choose this method will only save logs
when they manually tell the Switch to do so, using the save all or
save log command.
time_interval <minutes 1-65535> – Use this parameter to configure
the time interval that will be implemented for saving logs. The logs
will be saved every x number of minutes that are configured here.
Only Administrator or operator-level users can issue this command.

BANNER COMMANDS

419
55