Ethernet Oam Commands; Config Ethernet_Oam Ports - D-Link DGS-1210/ME Series Reference Manual

The Ethernet OAM commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config ethernet_oam
ports
config ethernet_oam
ports
config ethernet_oam
ports
show ethernet_oam
ports
show ethernet_oam
ports
show ethernet_oam
ports
show ethernet_oam
ports
clear ethernet_oam
ports
Each command is listed in detail, as follows:

config ethernet_oam ports

Purpose
Syntax
Description
Parameters
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

ETHERNET OAM COMMANDS

Parameter
[<portlist> | all] mode [active | passive] {received_remote_loopback [ignore |
process] | remote_loopback [start | stop] | state [enable | disable]}
[<portlist> | all] critical_link_event [critical_event | dying_gasp] notify_state
[enable | disable]
[<portlist> | all] link_monitor [error_frame | error_frame_period |
error_frame_seconds | error_symbol] notify_state [enable | disable] {threshold
<integer 1-4294967295> | window <integer 1000-60000>}
[<portlist> | all] status
[<portlist> | all] configuration
[<portlist> | all] statistics
[<portlist> | all] event_log {index <value_list>}
[<portlist> | all] [event_log | statistics]
Used to configure Ethernet OAM mode.
config ethernet_oam ports [<portlist> | all] mode [active |
passive] {received_remote_loopback [ignore | process] |
remote_loopback [start | stop] | state [enable | disable]}
The config ethernet_oam ports command is used to configure
ports Ethernet OAM to operate in active or passive mode. The
following two actions are allowed by ports in active mode, but
disallowed by ports in passive mode.
<portlist> − Specifies a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
mode – Specifies to operate in either active mode or passive mode.
The default mode is active.
received_remote_loopback [ignore | process] – Specifies the
received remote loopback to be ignore or process.
remote_loopback [start | stop] – Specifies the remote loopback to be
started or stopped.
306
39