Show Port Dot1V; Show Gvrp - D-Link DGS-1210/ME Series Reference Manual

show port dot1v

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the protocol VLAN information for ports 1 to 2:
DGS-1210-28MP/ME:5# show port dot1v ports 1-2
Command: show port dot1v ports 1-2
Port: 1
No valid dot1v entry!
Port: 2
No valid dot1v entry!
Total Entries: 0
DGS-1210-28MP/ME:5#

show gvrp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display GVRP port 5~8 status:
DGS-1210-28MP/ME:5# show gvrp 5-8
Command: show gvrp 5-8
Global GVRP : Enable
Port PVID
---- ----
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To display the VLAN to be associated with untagged packets
ingressed from a port based on the protocol group.
show port dot1v {ports <portlist>}
The show port dot1v command is used to display the VLAN to be
associated with untagged packets ingressed from a port based on
the protocol group.
ports <portlist> − Specify a range of ports to be displayed. If not
specified, information for all ports will be displayed.
None.
To display the GVRP status for a port list or port channel on the
Switch.
show gvrp {<portlist>}
The show gvrp command displays the GVRP status for a port list or
a port channel on the Switch.
<portlist> − Specifies a port or range of ports for which the GVRP
status is to be displayed.
None.
GVRP State Ingress Checking
---------- -----------------------
Acceptable Frame Type
---------------------------------
269