Show Address_Binding Ip_Mac Log; Config Address_Binding Auto_Scan; Config Address_Binding Auto_Scan Ipv6Address - D-Link DGS-1210/ME Series Reference Manual

Success.
DGS-1210-28MP/ME:5#

show address_binding ip_mac log

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display address binding IP MAC log information on the Switch:
DGS-1210-28MP/ME:5# show address_binding ip_mac log
Command: show address_binding ip_mac log
Log status: IPv4
DGS-1210-28MP/ME:5#

config address_binding auto_scan

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure address binding auto scan on the Switch:
DGS-1210-28MP/ME:5# config address_binding auto_scan from_ip 10.0.0.10 to_ip
10.0.0.12
Command: config address_binding auto_scan from_ip 10.0.0.10 to_ip 10.0.0.12
Success.
DGS-1210-28MP/ME:5#

config address_binding auto_scan ipv6address

Purpose
Syntax
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Used to display an IP-MAC-port binding IP MAC log information.
show address_binding ip_mac log
The show address_binding ip_mac log command is used to
display an IP-MAC-port binding IP MAC log information.
None.
None.
Used to configure an IP-MAC-port binding auto scan for specified IP
addresses.
config address_binding auto_scan from_ip <ipaddr> to_ip
<ipaddr>
The config address_binding auto_scan command is used to
configure the IP-MAC-port binding auto scan for specified IP
addresses.
<ipaddr> − Specifies a range of IP addresses for address binding
auto scan on the Switch.
Only administrator or operate-level users can issue this command.
Used to configure an IP-MAC-port binding auto scan for specified
IPv6 addresses.
config address_binding auto_scan ipv6address from_ip
76