Config Rspan Vlan - D-Link DGS-1210/ME Series Reference Manual

config rspan vlan

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create and RSPAN VLAN entry by VLAN ID 1:
DGS-1210-28MP/ME:5# config rspan vlan vlanid 1 source add ports 1-5 both
target 8
Command: config rspan vlan vlanid 1 source add ports 1-5 both target 8
Success.
DGS-1210-28MP/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the source setting for the RSPAN VLAN on the
source switch or configures the redirect port on the intermediate
switch and destination switch.
config rspan vlan [<vlan_name 32> | vlanid <vlanid_list>]
[redirect [add | delete] ports <portlist> | source [add | delete]
ports <portlist> [rx|tx|both] target <port 1-28> ]
The config rspan vlan command is used to configure the source
setting for the RSPAN VLAN on the source switch or configures the
redirect port on the intermediate switch and destination switch.
<vlan_name 32> - Enter the VLAN name to be created.
vlanid <vlanid_list> - Enter the VLAN ID to be created.
redirect - Specify output portlist for the RSPAN VLAN packets. If the
redirect port is a Link Aggregation port, there will perform the Link
Aggregation behavior for RSPAN packets.
[add | delete] - Specify to add or delete output ports for the RSPAN
VLAN packets.
ports <portlist> - Specify the ports that will be used for the RSPAN
VLAN packets.
source - If the ports are not specified by this command, the source of
RSPAN will come from the source specified by the mirror command
or the flow-based source specified by an ACL.
[add | delete] – Specify to add or delete source ports.
ports <portlist> - Specify the ports that will be add or delete from the
RSPAN source.
[rx | tx | both] – Specify to monitor ingress (rx), egress (tx) or ingress
and egress packets.
Only Administrator, operator and power user-level users can issue
this command.
398