Config Cos Protocol_Mapping; Show Cos Protocol_Mapping - D-Link DGS-1210/ME Series Reference Manual

DGS-1210-28MP/ME:5#

config cos protocol_mapping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the CoS mapping on the Switch:
DGS-1210-28MP/ME:5# config cos protocol_mapping protocol 10 class 1
Command: config cos protocol_mapping protocol 10 class 1
Success.
DGS-1210-28MP/ME:5#

show cos protocol_mapping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the CoS protocol mapping on the Switch:
DGS-1210-28MP/ME:5# show cos protocol_mapping
Command: show cos protocol_mapping
IP Protocol
--------------------------------------
10
DGS-1210-28MP/ME:5#
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To configure the CoS protocol mapping method on the Switch.
config cos protocol_mapping protocol <ip_protocol 1-255>
class <class_id 0-7>
The config cos protocol_mapping command is used to configure
the CoS protocol mapping method on the Switch.
<ip_protocol 1-255> - Specifies the protocol IP to be mapped.
<class_id 0-7> - Specifies the number of the Switch's hardware
priority queue.
Only administrator or operator-level users can issue this command.
To display the CoS protocol mapping information between an
incoming packet's 802.1p priority value.
show cos protocol_mapping {protocol <ip_protocol 1-255>}
The show cos protocol_mapping command is used to display the
CoS protocol mapping information between an incoming packet's
802.1p priority value.
<ip_protocol 1-255> - Specifies the mapped protocol IP to be
displayed.
None.
Class
1
207