DGS-3620 m/ mSW Rls. 1.02.000
10-2 snmp-server enable traps mpls
snmp-server enable traps mpls
no snmp-server enable traps mpls
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch(config)# snmp-server enable traps mpls
CLI Reference Guide
Use snmp-server enable traps mpls command to enable MPLS trap state. Use
the no form of this command to disable MPLS trap state.
None
Disabled
Global configuration mode
This command used to configure the MPLS LSP trap state. If the state is
enabled, a trap is sent out when an LSP's operation status changes to up or
down.
The user can verify their settings by entering the show mpls command.
This example shows how to enable MPLS trap state:
snmp-server enable traps mpls
267