Config Sflow Flow_Sampler Ports; Delete Sflow Flow_Sampler Ports - D-Link DGS-1210/ME Series Reference Manual

config sflow flow_sampler ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the sFlow sampler the rate of port 1 to be 0:
DGS-1210-28MP/ME:5# config sflow flow_sampler ports 1 rate 0 maxheadersize 18
Command: config sflow flow_sampler ports 1 rate 0 maxheadersize 18
Success.
DGS-1210-28MP/ME:5#

delete sflow flow_sampler ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Used to configure the sFlow flow sampler parameters. In order to
change the analyzer_server_id, delete the flow_sampler first and
create a new one.
config sflow flow_sampler ports [<portlist> | all] [rate <int 0-
65535> | tx_rate <int 0-65535> | maxheadersize <int 18-256>]
The config sflow flow_sampler ports command is used to
configure the sFlow flow sampler parameters. In order to change the
analyzer_server_id, delete the flow_sampler first and create a new
one.
<portlist> | all – Specify the list of ports or all port to be configured.
rate <int 0-65535> – The sampling rate for packet Rx sampling. The
configured rate value multiplied by x is the actual rate, where the x is
project dependent with the default value 256. If set to 0, the sampler
is disabled. This value must be between 0 and 65535, and the
default value is 0.
tx_rate <0-65535> – The sampling rate for packet Tx sampling. This
value must be between 0 and 65535, and the default value is 0.
maxheadersize <int 18-256> – The maximum number of leading
bytes in the packet which has been sampled that will be
encapsulated and forwarded to the server. This value must be
between 18 and 256, and the default value is 128.
Only Administrator, operator and power user-level users can issue
this command.
Used to delete the sFlow flow sampler.
delete sflow flow_sampler ports [<portlist> | all]
The delete sflow flow_sampler ports command is used to delete
the sFlow flow sampler.
<portlist> | all – Specify the list of ports or all ports to be deleted.
Only Administrator, operator and power user-level users can issue
this command.
403