Enable Jumbo_Frame - D-Link DGS-1210/ME Series Reference Manual

Mapping Status
RPS Power On
Internal Power & RPS Power On
RPS No Power
When the devices are using the specific PSU (P/N SU54-21124-000S) with charger function, the internal power
and external power (battery) status were shown according to different mapping definitions below (Only for DGS-
1210-10/ME, DGS-1210-20/ME, DGS-1210-28/ME and DGS-1210-52/ME):
Mapping Status
No LEI Power Supply
Battery Discharge Current OCP >
No AC In Use, Discharge, Battery Voltage <
No AC In Use, Discharge, Battery Voltage > 11.6V±0.2V
Battery Is Not Installed
AC In Use, Charging, Battery Voltage >
Battery Charging Current OCP >
AC In Use, Charging, Battery Voltage <

enable jumbo_frame

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable jumbo frames:
DGS-1210-28/ME:5# enable jumbo_frame
Command: enable jumbo_frame.
Success.
DES-1210-52/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
4.3A±0.1A
1.0A±0.1A
NOTE: For the specific PSU (P/N SU54-21124-000S), it is optional 54W AC to
DC Power Supply Unit (PSU) with external lead-acid battery support that can be
used as a redundant power supply, or to connect an external 12V DC lead-acid
battery to charge the switch. The minimum required voltage for the lead-acid
battery is 12V DC, with a minimum capacity of 2 AH (Only for DGS-1210-
10/ME, DGS-1210-20/ME, DGS-1210-28/ME and DGS-1210-52/ME).
To enable jumbo frames on the device.
enable jumbo_frame
The enable jumbo_frame command enables jumbo frames on the
device.
None.
Only Administrator or operate-level users can issue this command.
Jumbo frames will be enabled after save and restart.
Internal
Status
Disconnected
Working
Working
Internal
Status
Other
Disconnected
11.6V±0.2V
Disconnected
Disconnected
Working
12.8V±0.2V
Working
Over Current
12.8V±0.2V
Working
16
Power
RPS Satus
Working
Working
Disconnected
Power External Power
Satus (Battery)
Other
Over Current
Low Voltage
Working
Disconnected
Connected
Fail
Low Voltage