Description
Parameters
Restrictions
Example usage:
To configure the Switch location to "HQ":
DGS-1210-28MP/ME:5# config snmp system_location HQ
Command: config snmp system_location HQ
Success.
DGS-1210-28MP/ME:5#
config snmp system_name
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch name for "DGS-1210:
DGS-1210-28MP/ME:5# config snmp system_name DGS-1210
Command: config snmp system_name DGS-1210
Success.
DGS-1210-28MP/ME:5#
config snmp warmstart_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SNMP warm start traps for the Switch:
DGS-1210-28MP/ME:5# config snmp warmstart_traps enable
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
The config snmp system_ location command is used to enter a
Description of the location of the Switch. A maximum of 20
characters can be used.
<string 128> − A maximum of 128 characters is allowed. A NULL
string is accepted if there is no location desired.
Only Administrator or operator-level users can issue this command.
To configure the name of the location of the Switch.
config snmp system_name <string 128>
The config snmp system_ name command configures the name of
the Switch.
<string 128> − A maximum of 128 characters is allowed. A NULL
string is accepted if there is no location Desired.
Only Administrator or operator-level users can issue this command.
To enable or disable the warm start traps of SNMPon the Switch.
config snmp warmstart_traps [enable | disable]
The config snmp warmstart_traps command enable or disable the
warm start traps of the Switch.
[enable | disable] – Enable or disable the warm start traps of the
Switch.
Only Administrator or operator-level users can issue this command.
111