Show Duld Ports; Config Duld Recover_Timer - D-Link DGS-1210/ME Series Reference Manual

To enable unidirectional link detection on port 1:
DGS-1210-28MP/ME:5# config duld ports 1 state enable
Command: config duld ports 1 state enable
Success.
DGS-1210-28MP/ME:5#

show duld ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show unidirectional link detection information of port 1:
DGS-1210-28MP/ME:5# show duld ports 1
Command: show duld ports 1
port Admin State Oper Status Mode
------ ------------------- ----------------- --------
1 Enabled
DGS-1210-28MP/ME:5#

config duld recover_timer

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To show unidirectional link detection information.
show duld ports {<portlist> | all}
This show duld ports command is used to show unidirectional link
detection information.
[<portlist> | all] – Specifies a port, a range of ports or all ports to be
displayed.
None.
Disabled Normal
To configure unidirectional link detection recover time.
config duld recover_timer [0 | <sec 60-1000000>]
The config duld recover_timer command is used to configure
unidirectional link detection recover time.
[0 | <sec 60-1000000>] – Specifies the recover time of unidirectional
link detection function.
Only Administrator and operator-level users can issue this
command.
Link Status Discovery Time(Sec)
----------------- -------------------
Unknown 10
412