Enable Erps - D-Link DGS-1210/ME Series Reference Manual

Command
config erps instance
config erps instance
config erps instance
config erps instance
config erps instance
show erps instance
erps clear instance
erps force switch
instance
erps manual switch
instance
config erps version
Each command is listed in detail, as follows:

enable erps

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable ERPS:
DGS-1210-28MP/ME:5# enable erps
Command: enable erps
Success.
DGS-1210-28MP/ME:5#
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
<value 1-16> mel <value 0-7>
<value 1-16> [rpl_port [west | east | none] | rpl_role [owner | neighbor | none]]
<value 1-16> protected_vlan [add | delete] vlanid <vidlist>
<value 1-16> timer [holdoff_time <integer 0-1000> | guard_time <integer 10-
2000> | wtr_time <integer 1-12>]
<value 1-16> revertive [enable | disable]
<value 1-16> {sub_ring_instance}
<value 1-16>
<value 1-16> ring_port [west | east]
<value 1-16> ring_port [west | east]
[g.8032v1 | g.8032v2]
Used to enable the global ERPS function on a switch. When both
the global state and the specified ring ERPS state are enabled, the
specified ring will be activated.
enable erps
The enable erps is used to enable the ERPS function on a switch.
STP and LBD should be disabled on the ring ports before enabling
ERPS. ERPS cannot be enabled before the R-APS VLAN is created,
and ring ports, and RPL port, and RPL owner, are configured. Note
that these parameters cannot be changed when ERPS is enabled. In
order to guarantee correct operation, the following integrity will be
chedked when ERPS is enabled.
None.
Only Administrator, operator and power user-level users can issue
this command.
235