Show Snmp Host; Enable Snmp Traps - D-Link DGS-1100-16/ME Reference Manual

Success.
DGS-1100-24P/ME:admin#

show snmp host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1100-24P/ME:admin#show snmp host
Command : show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name
------------------------- ----------------------- ----------------
10.90.90.22
Total Entries : 1
DGS-1100-24P/ME:admin#

enable snmp traps

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SNMP trap support on the Switch:
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
To display the recipient of SNMP traps generated by the Switch's
SNMP agent.
show snmp host
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps generated by the Switch's
SNMP agent.
None.
None.
v2c
To enable SNMP trap support.
enable snmp traps
The enable snmp traps command enables SNMP trap support on
the Switch.
None.
Only administrator-level users can issue this command.
DGS-1100-24P/ME:admin#enable snmp traps
Command : enable snmp traps
private
41