Config Filter Dhcpv6_Server Ports; Config Filter Dhcpv6_Server Log; Create Filter Dhcpv6_Server Permit_Entry - D-Link DGS-1210/ME Series Reference Manual

config filter dhcpv6_server ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the filter DHCPv6 server state to be enabled for ports 1 to 8:
DGS-1210-28MP/ME:5# config filter dhcpv6_server ports 1-8 state enable
Command: config filter dhcpv6_server ports 1-8 state enable
Success.
DGS-1210-28MP/ME:5#

config filter dhcpv6_server log

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the Filter DHCPv6 Server log state:
DGS-1210-28MP/ME:5# config filter dhcpv6_server log state enable
Command: config filter dhcpv6_server log state enable
Success.
DGS-1210-28MP/ME:5#

create filter dhcpv6_server permit_entry

Purpose
Syntax
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the state of filter DHCPv6 server packets on the
switch. The filter DHCPv6 server function is used to filter the
DHCPv6 server packets on the specifie port(s) and receive the trust
packets from the specific source. This feature can be protected
network usable when a malicious host sends the DHCPv6 server
packets.
config filter dhcpv6_server ports <portlist> state [disable |
enable]
The config filter dhcpv6_server ports command is used to
configure the state of filter DHCPv6 server packets on the switch.
<portlist> - Specifies the list of ports to be configured.
state [disable | enable] – Specifies whether the port's filter DHCPv6
server function is enabled or disabled.
Only administrator or operate-level users can issue this command.
To enable or disable the Filter DHCPv6 server log state.
config filter dhcpv6_server log state [enable | disable]
The config filter dhcpv6_server log command is used to enable or
disable the Filter DHCPv6 server log state.
state [enable | disable] – Specify that the log for the Filter DHCPv6
server will be enabled or disabled.
Only administrator or operate-level users can issue this command.
Used to create a filter DHCPv6 server permit entry.
create filter dhcpv6_server permit_entry <ipv6addr> ports
68