Description
Parameters
Restrictions
Example usage:
To display the current scheduling configuration:
DGS-1210-28MP/ME:5# show scheduling
Command: show scheduling
QOS Output Scheduling
Class ID
--------
Class-0
Class-1
Class-2
Class-3
Class-4
Class-5
Class-6
Class-7
DGS-1210-28MP/ME:5#
config bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
The show scheduling command displays the current configuration
for the maximum number of packets (max_packet) value assigned to
the four priority classes of service on the Switch. The Switch empties
the four hardware queues in order, from the highest priority (class 3)
to the lowest priority (class 0).
None.
None.
Weight
----------
strict
strict
strict
strict
strict
strict
strict
strict
To configure bandwidth control on the Switch.
config bandwidth control [<portlist> | all] {rx_rate [no_limit |
<value 63-1000000>] | tx_rate [no_limit | <value 63-1000000>]}
The config bandwidth_control command defines bandwidth
control.
portlist - A port or range of ports to be configured.
all - Specifies that the config bandwidth_control command applies
to all ports on the Switch.
rx_rate - Enables ingress rate limiting
•
no_limit – Indicates no limit is defined.
•
<value 63–1000000>] – Indicates a range between 63-
1000000 kbps.
tx_rate – Enables egress rate limiting.
•
no_limit – Indicates no limit is defined.
•
<value 63–1000000>] – Indicates a range between 63-
1000000 kbps.
Only administrator-level users can issue this command.
199