Parameters
Restrictions
Example usage:
To enable the ERPS ring state:
DGS-1210-28MP/ME:5# config erps raps_vlan 4094 state enable
Command: config erps raps_vlan 4094 state enable
Success.
DGS-1210-28MP/ME:5#
config erps raps_vlan sub_ring
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a sub-ring connected to another ring:
DGS-1210-28MP/ME:5# config erps raps_vlan 4094 add sub_ring raps_vlan 2
Command: config erps raps_vlan 4094 add sub_ring raps_vlan 2
Success.
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
are configured. Note that these parameters cannot be changed
when the ring is activated.
In order to guarantee correct operation, the following integrity will be
checked when the ring instance is enabled and the global ERPS
state is enabled.
1.
R-APS VLAN is created.
2.
The Ring port is the tagged member port of the R-APS
VLAN.
3.
The RPL port is specified if RPL owner is enabled.
4.
The RPL port is not virtual channel.
5.
The Ring port is the master port if it belongs to a link
aggregation group.
<vlanid 1-4094> - Specifies the VLAN id to be configured.
state [enable | disable] – Specifies to enable or disable the state of
the specified ring.
Only Administrator, operator and power user-level users can issue
this command.
Used to configure a sub-ring connected to another ring.
config erps raps_vlan <vlanid 1-4094> [add | delete] sub_ring
raps_vlan <vlanid 1-4094>
The config erps raps_vlan sub_ring command is used to
configure a sub-ring's default instance connected to another ring's
default instance. This command is applied on the interconnection
node.
<vlanid 1-4094> - Specifies the R-APS VLAN id to be configured.
[add | delete] – Specifies add to connect the rub-ring to another ring.
Or specify delete to disconnect the sub-ring from the connected ring.
Only Administrator, operator and power user-level users can issue
this command.
241