The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config arp_aging time
clear arptable
create arpentry
config arpentry
delete arpentry
show arpentry
show arpentry
aging_time
Each command is listed in detail, as follows:
config arp_aging time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ARP aging time:
DGS-1210-28MP/ME:5# config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-1210-28MP/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<value 0-65535 >
<ipaddr> <macaddr>
<ipaddr> <macaddr>
[<ipaddr> | all]
{information | interface_name {system} | ip_address <ipaddr> | mac_address
<macaddr> | summary}
To configure the age-out timer for ARP table entries on the Switch.
config arp_aging time <value 0-65535>
The config arp_aging time command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch's ARP
table, without being accessed, before it is dropped from the table.
<value 0-65535> – The ARP age-out time, in minutes. The value
may be in the range of 0-65535 minutes, with a default setting of 20
minutes.
Only Administrator or operator-level users can issue this command.
ARP COMMANDS
392
50