Create Authen Server_Group; Config Authen Server_Group - D-Link DGS-1210/ME Series Reference Manual

DGS-1210-28MP/ME:5# show authen server_host
Command: show authen server_host
IP Address
---------------
10.1.1.121
Total Entries : 1
DGS-1210-28MP/ME:5#

create authen server_group

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a server group "dlinkgroup":
DGS-1210-28MP/ME:5# create authen server_group dlinkgroup
Command: create authen server_group dlinkgroup
Success.
DGS-1210-28MP/ME:5#

config authen server_group

Purpose
Syntax
Description
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Protocol Port Timeout Retransmit Key
-------------- ------ ------------ ----- ---------- --------------------
tacacs+ 4321 ------
To create an authentication server host.
create authen server_group <string 15>
The create authen server_ group command creates an
authentication server group for the protocols on the Switch.
<string 15> – Defines the authentication group name as a string of
up to 15 alphanumeric characters.
Only Administrator-level users can issue this command.
To configure a user-defined authentication server host.
config authen server_group [<string 15> | radius | tacacs+] [add
| delete] server_host [<ipaddr> | ipv6address <ipv6addr>]
protocol [radius | tacacs+]
The config authen server_ group command configures a user-
defined authentication server group for the TACACS+/RADIUS
security protocols on the Switch. When a user attempts to access
the Switch with the authentication protocol enabled, the Switch
sends authentication packets to a remote TACACS+/RADIUS server
group on a remote host. The TACACS+/RADIUS server group then
verifies or denies the request and returns the appropriate message
to the Switch. More than one authentication protocol can be run on
the same physical server host but, remember that
TACACS+/RADIUS are separate entities and are not compatible
-1
450