Config Cos Mapping; Show Cos Mapping - D-Link DGS-1210/ME Series Reference Manual

config cos mapping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the CoS mapping on the Switch:
DGS-1210-28MP/ME:5# config cos mapping port all 802.1p
Command: config cos mapping port all 802.1p
Success.
DGS-1210-28MP/ME:5#

show cos mapping

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the CoS mapping on the Switch:
DGS-1210-28MP/ME:5# show cos mapping port 1-5
Command: show cos mapping port 1-5
Port Ethernet_Priority
------------------------------------------------------
1
2
3
4
5
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To configure the method of which incoming packets will be identified
for the CoS to port mapping feature.
config cos mapping port [<portlist> | all] [802.1p | dscp_tos |
none]
The config cos mapping port command is used to configure the
method of which incoming packets will be identified for the CoS to
port mapping feature on the Switch.
<portlist> - A port or range of ports to be configured.
all - Specifies all ports to be configured on the Switch.
[802.1p | dscp | none] – Specified which incoming packets will be
identified for the CoS.
Only administrator or operator-level users can issue this command.
To display the information regarding CoS mapping enabled ports
and their mapping method.
show cos mapping {port <portlist>}
The show cos mapping command displays the information
regarding CoS mapping enabled ports and their mapping method.
<portlist> - A port or range of ports to be displayed.
None.
IP_Priority
802.1p DSCP
802.1p DSCP
802.1p DSCP
802.1p DSCP
802.1p DSCP
206