Traceroute - D-Link DGS-1210/ME Series Reference Manual

Metro ethernet switches
Hide thumbs Also See for DGS-1210/ME Series:
Table of Contents

Advertisement

Restrictions
Example usage:
To ping the IPv6 address to "3000::1" four times:
DGS-1210-28MP/ME:5# ping6 3000::1 times 4
Command: ping6 3000::1 times 4
Reply From : 3000::1, bytes=200, time<10ms
Reply From : 3000::1, bytes=200, time<10ms
Reply From : 3000::1, bytes=200, time<10ms
Reply From : 3000::1, bytes=200, time<10ms
--- 3000::1 Ping Statistics ---
4 Packets Transmitted, 4 Packets Received, 0% Packets Loss
DGS-1210-28MP/ME:5#

traceroute

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To trace route IP 10.90.90.92 with max-ttl is 10:
DGS-1210-28MP/ME:5# traceroute 10.90.90.92 max-ttl 10
Command: traceroute 10.90.90.92 max-ttl 10
Tracing Route to 10.90.90.92 with 10 hops max and 1 byte packets
[!N - Network Unreachable !H - Host Unreachable !P - Protocol Unreachable]
1
0.0.0.0
2
0.0.0.0
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
used as the packets' source IPv6 address that ping6 sends to the
remote host.
timeout <sec 1-99> - The time-out period while waiting for a
response from the remote device. A value of 1 to 99 seconds can be
specified. The default is 1 second.
times <value 1-255> - The number of individual ICMP echo
messages to be sent. The maximum value is 255. The default is 4.
None.
The traceroute User EXEC mode command discovers routes that
packets actually take when traveling to their destination.
traceroute <ip_addr> {[max-ttl <short 1-99> | min-ttl <short 1-
99>}
The traceroute command discovers routes that packets actually
take when traveling to their destination.
<ip_addr> - Specifies the IP address of the destination host.
max-ttl <short 1-99> - The largest TTL value that can be used.
The traceroute command
reached or when this value is reached.
min-ttl <short 1-99> - The smallest TTL value that can be used.
The traceroute command
reached or when this value is reached.
Only Administrator or operate-level users can issue this command.
*
*
terminates
when the
terminates
when the
*
*
*
*
28
destination
is
destination
is

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents