Config Autoconfig; Show Autoconfig; Save - D-Link DGS-1210/ME Series Reference Manual

DGS-1210-28MP/ME:5#

config autoconfig

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the auto configuration timeout time to 100 seconds:
DGS-1210-28MP/ME:5# config autoconfig timeout 100
Command: config autoconfig timeout 100
Success.
DGS-1210-28MP/ME:5#

show autoconfig

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the autoconfig status:
DGS-1210-28MP/ME:5# show autoconfig
Command: show autoconfig
Autoconfig State : Enabled
Timeout
DGS-1210-28MP/ME:5#

save

Purpose
Syntax
Description
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Use to configure the auto configuration timeout time from DHCP.
config autoconfig timeout <value 1-65535>
The config autoconfig command is used to the auto configuration
timeout time from DHCP.
timeout <value 1-65535> - Specifies the timeout time. And the value
is from 1 to 65535 seconds.
Only Administrator or operator-level users can issue this command.
Used to display the current autoconfig status of the Switch.
show autoconfig
The show autoconfig command is used to list the current status of
the auto configuration function.
None.
None.
: 50 sec
To save changes in the Switch's configuration to non-volatile RAM.
save {[config config_id <value 1-2> | log]}
The save command used to enter the current switch configuration
into non-volatile RAM. The saved switch configuration will be loaded
into the Switch's memory each time the Switch is restarted.
22