Safeguard Commands; Config Safeguard_Engine; Show Safeguard_Engine - D-Link DGS-1210/ME Series Reference Manual

The Safeguard commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config
safeguard_engine
show
safeguard_engine
Each command is listed in detail, as follows:

config safeguard_engine

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the safeguard engine on the switch:
DGS-1210-28MP/ME:5# config safeguard_engine state enable
Command: config safeguard_engine state enable
Success.
DGS-1210-28MP/ME:5#

show safeguard_engine

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
state [enable | disable]
To define the safeguard engine on the switch.
config safeguard_engine state [enable | disable]
To define the safeguard_engine on the switch.
state [enable | disable] – enable and disable Safeguard engine on
the Switch.
Only Administrator or operator-level users can issue this command.
To show the safeguard engine status on the switch.
show safeguard_engine
To show the safeguard engine on the switch.
None.
Only Administrator or operator-level users can issue this command.

SAFEGUARD COMMANDS

493
66