Traffic Segmentation Commands; Config Traffic_Segmentation; Show Traffic_Segmentation - D-Link DGS-1210/ME Series Reference Manual

Metro ethernet switches
Hide thumbs Also See for DGS-1210/ME Series:
Table of Contents

Advertisement

The Traffic Segmentation commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config
traffic_segmentation
show traffic_
segmentation
Each command is listed in detail, as follows:

config traffic_segmentation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 3~4 to be able to forward frames to port 4~5:
DGS-1210-28MP/ME:5# config traffic_segmentation 3-4 forward_list 4-5
Command: config traffic_segmentation 3-4 forward_list 4-5
Success.
DGS-1210-28MP/ME:5#

show traffic_segmentation

Purpose
Syntax
Description
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide

TRAFFIC SEGMENTATION COMMANDS

Parameter
<portlist> forward_list [null | <portlist>]
{<portlist>}
To configure traffic segmentation on the Switch.
config traffic_segmentation <portlist> forward_list [null |
<portlist>]
The config traffic_segmentation command configures traffic
segmentation on the Switch.
<portlist> – A port or a port channel for which the current traffic
segmentation configuration on the Switch is to be displayed.
forward_list – Specifies a port or a port channel to receive forwarded
frames from the source ports specified in the portlist, above.
Only administrator or operator-level users can issue this command.
To display the current traffic segmentation configuration on the
Switch.
show traffic_segmentation {<portlist>}
The show traffic_segmentation command displays the current
traffic segmentation configuration on the Switch.
491
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents