Config Greeting_Message - D-Link DGS-1210/ME Series Reference Manual

config greeting_message

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210-28MP/ME:5# config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
DGS-1210-28MP/ME Gigabit Ethernet Switch
Copyright(C) 2012 D-Link Corporation. All rights reserved.
================================================================================
<Function Key>
Ctrl+C Quit without save
Ctrl+W Save and quit
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Used to configure the login banner (greeting message).
config greeting_message {default}
The config greeting_message command to modify the login
banner (greeting message).
default – If the user enters default to the modify banner command,
then the banner will be reset to the original factory banner.
To open the Banner Editor, click Enter after typing the config
greeting_message command. Type the information to be displayed
on the banner by using the commands DGScribed on the Banner
Editor:
Quit without save: Ctrl+C
Save and quit: Ctrl+W
Move cursor: Left/Right/Up/Down
Delete line: Ctrl+D
Erase all setting: Ctrl+X
Reload original setting: Ctrl+L
Only Administrator and Operator-level users can issue this
command. Other restrictions include:
If the "reset" command is executed, the modified banner will remain
modified. However, the "reset config/reset system" command will
reset the modified banner to the original factory banner.
The capacity of the banner is 6*80. 6 Lines and 80 characters per
line.
Ctrl+W will only save the modified banner in the DRAM. Users need
to type the "save config/save all" command to save it into Flash.
Only valid in threshold level.
Command Line Interface
Firmware: Build 7.01.B030
<Control Key>
left/right/
up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
43