Poe Commands; Config Poe Ports - D-Link DGS-1210/ME Series Reference Manual

The PoE commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command

config poe ports

config por system
show poe ports
show poe system
Each command is listed in detail, as follows:
config poe ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure PoE with ports 8-10:
DGS-1210-28MP/ME:5# config poe ports 8-10 power_limit Auto priority low state
enable
Command: config poe ports 8-10 power_limit Auto priority low state enable
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
[all | <portlist>] {clear_time_range | power_limit [auto | class_1 | class_2 | class_3
| class_4 | user_define <value 1-30>] | priority [high | normal | low] | state [enable
| disable] | time_range <range_name 32>}
[legacy_pd [enable | disable] | power_disconnect_method
[deny_low_priority_port | deny_next_port] | power_limit <value 7-193>]
[all | <portlist>]
Used to configure the Power over Ethernet (PoE) functionality.
config poe
power_limit [auto | class_1 | class_2 | class_3 | class_4 |
user_define <value 1-30>] | priority [high | normal | low] | state
[enable | disable] | time_range <range_name 32>}
The config poe ports configures the Power over Ethernet (PoE)
functionality of the Switch.
all | <portlist> − Specifies the port or all ports to be configured with
PoE of the Switch.
clear_time_range – Specifies the time range to be cleared.
power_limit [auto | class_1 | class_2 | class_3 | class_4 |
user_define <value 1-30>] – Specifies the power limit with different
class or user defined. Auto will negotiate and follow the classification
from the PD power current based on the 802.3at standard.
priority [high | normal | low] – Specifies the priority of specified ports.
The default is normal.
state [enable | disable] – To configure the PoE function for
designated ports.
time_range <range_name 32> - To configure the time-based PoE
function on designated port(s).
Only Administrator or operator-level users can issue this command.
ports [all | <portlist>]
167

POE COMMANDS

{clear_time_range
22
|