Config Ddm Power_Unit; Show Ddm Ports - D-Link DGS-1210/ME Series Reference Manual

To configure the port 21's voltage threshold:
DGS-1210-28MP/ME:5# config ddm ports 1:21 temperature_threshold high_alarm
84.9555 low_alarm -10 high_warning 70 low_warning 2.25251
Command: config ddm ports 1:21 temperature_threshold high_alarm 84.9555
low_alarm -10 high_warning 70 low_warning 2.25251
Success.
DGS-1210-28MP/ME:5#

config ddm power_unit

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the DDM TX and RX power unit as dBm:
DGS-1210-28MP/ME:5# config ddm power_unit dbm
Command: config ddm power_unit dbm
Success.
DGS-1210-28MP/ME:5#

show ddm ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display ports 1-5's operating parameters:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To configure the unit of DDM TX and RX power.
config ddm power_unit [mw | dbm]
The config ddm power_unit command is used to configure the unit
of DDM TX and RX power.
mw - Specify the DDM TX and RX power unit as mW.
dbm - Specify the DDM TX and RX power unit as dBm.
Only Administrator or operator-level users can issue this command.
To display the current operating DDM parameters and configuration
values of the optic module of the specified ports.
show ddm ports <portlist> [configuration | status | vendor_info]
The config ddm power_unit command is used to display the
current operating DDM parameters and configuration values of the
optic module of the specified ports.
<portlist> - Specify the ports of DDM to be displayed.
configuration - Specifies that the configuration values will be
displayed.
status - Specifies that the operating parameter will be displayed.
vendor_info - Specifies that the vender information will be displayed.
None.
344