Config Serial_Port - D-Link DGS-1210/ME Series Reference Manual

Parameters
Restrictions
Example usage:
To display the serial port settings:
DGS-1210-28MP/ME:5# show serial_port
Command: show serial_port
Baud Rate
Data Bits
Parity Bits
Stop Bits
Auto-Logout : 10 minutes
DGS-1210-28MP/ME:5#

config serial_port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the serial port baud rate:
DGS-1210-28MP/ME:5# config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Please change your baud rate to 115200 for new baud rate !!
Success.
DGS-1210-28MP/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
None.
None.
: 9600
: 8
: None
: 1
Used to configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
The config serial_port command is used to configure the serial
port's baud rate and auto logout settings.
baud_rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that
will be used to communicate with the management host. There are
four options: 9600, 19200, 38400 and 115200. Factory default
setting is 115200.
never − No time limit on the length of time the console can be open
with no user input.
2_minutes − The console will log out the current user if there is no
user input for 2 minutes.
5_minutes − The console will log out the current user if there is no
user input for 5 minutes.
10_minutes − The console will log out the current user if there is no
user input for 10 minutes.
15_minutes − The console will log out the current user if there is no
user input for 15 minutes.
Only Administrator or operator-level users can issue this command.
18