Config Limited_Multicast_Addr; Show Limited_Multicast_Addr - D-Link DGS-1210/ME Series Reference Manual

config limited_multicast_addr

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 and 3 to set the IPv6 multicast address profile id 1:
DGS-1210-28MP/ME:5# config limited_multicast_addr ports 1,3 ipv6 add profile_id 1
Command: config limited_multicast_addr ports 1,3 ipv6 add profile_id 1
Success.
DGS-1210-28MP/ME:5#

show limited_multicast_addr

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the IPv4 limited multicast address on ports 1 and 3:
DGS-1210-28MP/ME:5# show limited_multicast_addr ports 1,3 ipv4
Command: show limited_multicast_addr ports 1,3 ipv4
Port Access
---- -----------
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To configure the multicast address filtering function a port.
config limited_multicast_addr ports <portlist> [ipv4 | ipv6] {[add
| delete] [profile_id <integer 1-24> | profile_name <string 20>] |
access [permit | deny]}
The config limited_multicast_addr command is used to configure
the multicast address filtering function on a port. When there are no
profiles specified with a port, the limited function is not effective.
ports <portlist> – A port or range of port on which the limited
multicast address range to be configured has been assigned.
[ipv4 | ipv6] – Specify the IPv4 or IPv6 of multicast filter profile to be
configured.
[add | delete] – Add or delete a multicast address profile to a port.
profile_id <integer 1-24> – A profile ID to be added or deleted from a
port.
profile_name <string 20> – A profile name to be added or deleted
from a port.
[permit | deny] – Specifies that the packet that matches the
addresses defined in the profiles will be permitted or denied. The
default mode is permit.
Only Administrator or operator-level users can issue this command.
Used to show the per-port Limited IP multicast address range.
show limited_multicast_addr ports <portlist> {[ipv4 | ipv6]}
The show limited_multicast_addr command is to display the
multicast address range by port or by VLAN.
<portlist> – Used to show the per-port Limited IP multicast address
range.
[ipv4 | ipv6] – Specify the IPv4 or IPv6 of limited multicast address to
be displayed.
None.
Profile ID List
--------------------------------------------------------------
364