Show 802.1X Fwd_Pdu System Status; Config 802.1X Auth_Mode - D-Link DGS-1210/ME Series Reference Manual

Example usage:
To enable 802.1x forwarding EAPOL PDU
DGS-1210-28MP/ME:5# config 802.1x fwd_pdu system enable
Command: config 802.1x fwd_pdu system enable
Success.
DGS-1210-28MP/ME:5#

show 802.1x fwd_pdu system status

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show 802.1x forwarding EAPOL PDU status:
DGS-1210-28MP/ME:5# show 802.1x fwd_pdu system status
Command: show 802.1x fwd_pdu system status
PNAC control packet (eap) is forwarding....
Success.
DGS-1210-28MP/ME:5#

config 802.1x auth_mode

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x authentication by port address:
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To display the 802.1x forwarding EAPOL PDU status on the Switch.
show 802.1x fwd_pdu system status
The show 802.1x fwd_pdu system status command is used to
display the control of forwarding EAPOL PDUs.
None.
None.
To configure the 802.1x authentication mode on the Switch.
config 802.1x auth_mode [port_based | mac_based]
The config 802.1x auth_mode command enables either the port-
based or MAC-based 802.1x authentication feature on the Switch.
[port_based | mac_based] – Specifies whether 802.1x
authentication is by port or MAC address.
Only Administrator, operator or power user-level users can issue this
command.
377