The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
create vlan
delete vlan
config vlan
config private_vlan
config private_vlan
trunk
show private_vlan
config gvrp
config pvid
config gvrp timer
enable gvrp
disable gvrp
show vlan
create
dot1v_protocol_group
group_id <id 1-16>
config
dot1v_protocol_group
delete
dot1v_protocol_group
show
dot1v_protocol_group
config port dot1v ports
show port dot1v
show gvrp
show gvrp timer
enable vlan_trunk
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Parameter
create vlan [<string 32> tag <int 2-4094> {[type_1q_vlan_advertisement |
private_vlan]}] | [vlanid <vidlist> {[type_1q_vlan_advertisement | private_vlan]}]
[<vlan_name 32> | vlanid <vidlist>]
[<vlan_name 32> | vlanid <vidlist>] [[add [tagged | untagged | forbidden] | delete ]
[<portlist> | name <vlan_name 32>] {advertisement [enable | disable]}
[vlan <vlan_name 32> | vlanid <int 1-4094>] [[add [isolated | community] |
remove ] [<vlan_name 32> | vlanid <vlanid_list>]
[promiscuous | secondary] [add | remove] ports <portlist>
{vlan <vlan_name 32> | vlanid <vlanid_list>}
[state [enable | disable] | ingress_checking [enable | disable] | acceptable_frame
[Tagged_Only | All_Frames] | pvid <vlanid 1-4094>]
<int 1-4094> ports <portlist>
[join_timer <sec 100-100000> | leave_timer <sec 100-100000> | leave-all_timer
<sec 100-100000>]
{<vlan_name 32> | vlanid <vidlist> | ports <portlist>}
{group_name <name 32>}
[group_id <id 1-6> | group_name <name 32>] [add | delete] protocol [ethernet_2
<hex 0x0-0sffff> | ieee802.3_snap <hex 0x0-0xffff>]
[group_id <id 1-16> | group_name <name 32> | all]
{group_id <id 1-16> | group_name <name 32>}
{[<portlist> | all]} [add | delete] protocol_group [group_name <name 32> |
group_id <id 1-16>] [vlan <vlan_name 32> | vlanid <id 1-4094>]
{ports <portlist>}
{<portlist>}
VLAN COMMANDS
258
32