Config Erps Instance Sub_Ring_Instance - D-Link DGS-1210/ME Series Reference Manual

Parameters
Restrictions
Example usage:
To enable ring instance 1 state:
DGS-1210-28MP/ME:5# config erps instance 1 state enable
Command: config erps instance 1 state enable
Success.
DGS-1210-28MP/ME:5#

config erps instance sub_ring_instance

Purpose
Syntax
Description
Parameters
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
the ring state of the specified instance. When the specified ring
instance state is enabled, the specified ring instance will be
activated. STP and LBD should be disabled on the physical ring
ports before the specified ring instance is activated.
The instance cannot be enabled before the R-APS VLAN is
designated, and physical ring ports, RPL port, RPL owner, are
configured. Note that these parameters cannot be changed when
the instance is activated.
In order to guarantee correct operation, the following integrity will be
checked when the instance is enabled:

R-APS VLAN is designated.

The physical ring port is the tagged member port of the R-APS
VLAN.

The RPL port is specified if RPL owner or neighbor is
designated.

STP or LBD enabled on the physical ring port.

The instance is sub ring instance but the virtual channel is not
existed

The Ring port is the master port if it belongs to a link
aggregation group.

The default state of the instance is disabled.
<value 1-16> – Specifies the instance ID to be configured.
state [enable | disable] – Specifies to enable or disable the state of
the specified ring instance. The default value is disabled.
Only Administrator, operator and power user-level users can issue
this command.
Used to configure a sub-ring instance connected to another ring
instance.
config erps instance <value 1-16> [add | delete]
sub_ring_instance <value 1-16>
The config erps instance sub_ring_instance commanmd is used
to configure a sub-ring instance connected to another ring instance.
This command is applied on the interconnection node.
<value 1-16> – Specifies the instance ID to be configured.
[add | delete] – Specifies add to connect the sub-ring instance to
another ring instance. Specifies delete to disconnect the sub-ring
249