Show Lldp Mgt_Addr - D-Link DGS-1210/ME Series Reference Manual

config lldp ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP mac_phy_configuration status:
DGS-1210-28MP/ME:5# config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Success.
DGS-1210-28MP/ME:5#

show lldp mgt_addr

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the LLDP management address advertisement:
DGS-1210-28MP/ME:5# show lldp mgt_addr
Command: show lldp mgt_addr
Address : 1
---------------------------------------------------------------
Subtype
Address
IF Type
OID
Advertising Ports
Total Address : 1
DGS-1210-28MP/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To define LLDP management basic TLVs advertisement on a port or ports.
config lldp ports [<portlist>|all] dot1_tlv_vlan_name [vlan <vlan_name
32> | vlanid <vidlist>] [disable | enable]
The config lldp ports dot1 TLVs command defines lldp admin status per
port on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
vlan <vlan_name 32> –The name of the VLAN to be configured.
dot1_tlv_vlan_name − Defines if the advertisement is enabled or disabled.
vlanid <vidlist> –The vid of the VLAN to be configured.
Only Administrator or operator-level users can issue this command.
To display the Link Layer Discovery Protocol (LLDP) configuration
that is advertised from a specific port.
show lldp mgt_addr {ipv4 <ipaddr> | ipv6 <ipv6addr>}
The show lldp mgt_addr command displays the information
regarding the IPv4 or IPv6 address.
ipv4 <ipaddr> | ipv6 <ipv6addr> – Specifies the lldp IPv4 or IPv6
address to be displayed.
None.
: IPv4
: 10.90.90.90
: ifIndex
: 1.3.6.1.2.1.2.2.1.1
: (NONE)
474