D-Link DGS-1210/ME Series Reference Manual page 491

Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP admin status
DGS-1210-28MP/ME:5# config lldp ports 2 admin_status disable
Command: config lldp ports 2 admin_status disable
Success.
DGS-1210-28MP/ME:5#
config lldp ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP management address advertisement:
DGS-1210-28MP/ME:5# config lldp ports 1 mgt_addr ipv4 100.1.1.2 enabled
Command: config lldp ports 1 mgt_addr ipv4 100.1.1.2 enabled
Success.
DGS-1210-28MP/ME:5#
config lldp ports
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
config lldp ports [<portlist> | all] admin_status [tx_only |
rx_only | tx_and_rx | disable]
The config lldp ports admin status command defines lldp admin
status per port on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
Admin status – Defines admin status of ports on the switch.
Tx- Tx only.
Rx – Rx only.
Both – Tx and RX.
Disable – admin status disabled.
None.
To define LLDP management address advertisement on a port or
ports.
config lldp ports [<portlist>|all] mgt_addr [ipv4 <ipaddr>| ipv6
<ipv6addr>] [enable | disable]
The config lldp ports mgt_addr command defines if lldp will
advertise the switch's IP address the command is per port on the
switch.
[<portlist> | all] – Specify a port or ports to be configured.
mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] – defines wether the
management address (IPv4 or IPv6 address) advertisement will be
enabled or disabled
Only Administrator or operator-level users can issue this command.
471