Enable Trusted_Host; Disable Trusted_Host - D-Link DGS-1210/ME Series Reference Manual

Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1210-28MP/ME:5# show snmp v6host
Command: show snmp v6host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address
------------------------------------
3000::1
Success.
DGS-1210-28MP/ME:5#

enable trusted_host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the trusted host on the Swtich:
DGS-1210-28MP/ME:5# enable trusted_host
Command: enable trusted_host
Success.
DGS-1210-28MP/ME:5#

disable trusted_host

Purpose
Syntax
Description
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
The show snmp host command is used to display the IPv6
addresses and configuration information of remote SNMP managers
that are DGSignated as recipients of SNMP traps generated by the
Switch's SNMP agent.
<ip6_addr> − The IPv6 address of a remote SNMP manager that
receives SNMP traps generated by the Switch's SNMP agent.
None.
SNMP Version
--------------------
V3-NoAuthNoPriv dlink
To enable the trusted host.
enable trusted_host
The enable trusted_host command enables the trusted host
feature.
None.
Only administrator or operator level users can issue this command.
To enable the trusted host.
disable trusted_host
The disable trusted_host command disables the trusted host
feature.
Community or User Name
-------------------------------------
103