Cable Diagnostic Port - D-Link DGS-1210/ME Series Reference Manual

Command: show syslog host
Host ID Host IP Address Severity
---------
1
Total Entries : 1
DGS-1210-28MP/ME:5#

cable diagnostic port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To determine the copper cables and position of port 3 on the Switch:
DGS-1210-28MP/ME:5# cable diagnostic port 15
Command: cable diagnostic port 15
Perform Cable Diagnostics ...
Port Type
------- -------
15 GE
DGS-1210-28MP/ME:5#
config syslogintimeout
Purpose
Syntax
Description
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
----------------------- -----------
1.1.2.1 All
To determine if there are any errors on the copper cables and the
position where the errors may have occurred.
cable diagnostic port [<portlist> | all]
The cable diagnostic port command is used to determine if there
are any errors on the copper cables and the position where the
errors may have occurred. Cable length is detected as following
range: <50m, 50~80, 80~100, >100m. Deviation is +/-5 meters,
therefore "No Cable" may be displayed under "Test Result," when
the cable used is less than 5 m in length. The Fault Distance will
show "No Cable", whether the fiber is connected to the port or not.
<portlist> – A port or range of ports to be configured.
all − Specifies all ports on the Switch are to be configured.
None.
Link Status
-------------------
Link Up
To configure the system login timeout.
config syslogintimeout <integer 3-30>
The config syslogintimeout command is used to configure the
system login timeout.
Facility UDP Port Status
------------ ------------- -----------
Local0 514
Test Result Cable Length (M)
------------------------- ----------------------------
OK
164
Enabled
4